Configuring Gateway Maintenance Tasks - RADVision SCOPIA 400 User Manual

Version 5.6
Hide thumbs Also See for SCOPIA 400:
Table of Contents

Advertisement

C
ONFIGURING
G
ATEWAY
M
AINTENANCE
T
ASKS
S
AVING
C
ONFIGURATION
S
ETTINGS
ICMP-in-message counter—Displays the number of Internet Control
Message Protocol (ICMP) packets received.
UDP-in-datagram counter—Displays the number of User Datagram
Protocol (UDP) packets received.
Packet loss counter—Displays the number of lost packets.
Packet late counter—Displays the number of late packets.
Accumulated time of B channel usage (PRI Gateways only)—Displays
the total B channel usage (in minutes).
Counter reset time—Displays the last time at which the counters were
reset.
Reset Counters button—Click to reset all counters to zero.
On the Maintenance tab, you can enter maintenance mode. In maintenance mode,
you can perform maintenance work on the Gateway, such as upgrading software.
In maintenance mode, the Gateway cannot accept new calls. You can disconnect
all calls currently active in the Gateway, or wait for them to disconnect. In
maintenance mode, you can only modify the following configuration settings:
Services (see
information)
Fractional B channel status (PRI Gateways only) (see
Channel Status
Gatekeeper IP connectivity (see
page 85 for more information).
Resource allocation
IVR (see
Configuring IVR Settings
To enter maintenance mode, click Enter Maintenance Mode. To exit
maintenance mode, click Exit Maintenance Mode.
You can save Gateway configuration settings to a file and then export this file to
a storage device on your network. You can use the saved configuration file to
restore the settings to the current Gateway unit or to configure a similar Gateway
unit.
An exported configuration file saves most of the current Board section settings
and all of the current Gateway section settings.
You cannot save configuration settings in the System category.
Note

Configuring Gateway Maintenance Tasks

About Gateway Services
on page 83 for more information)
Configuring IP Connectivity Settings
on page 92 for more information)
Configuring the SCOPIA Gateway
on page 123 for more
Viewing B
on
153

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scopia 1000

Table of Contents