Table of Contents
Advertisement
C
P
ONFIGURING
ORT
S
UPPORTED
S
ERVICES
timeout before all the digits have been dialed, the call might connect to a
different address or rejected. If you select this setting, perform
otherwise skip to
(PRI Gateways only) In the Incoming number of digits field, enter the
7
number of digits you want the Gateway to expect during overlap
receiving. The Gateway waits until this number of specified digits is
received and then processes the whole number. You can enter any value
up to 32.
8
(PRI Gateways only) In the Outgoing Calling Party Number field, enter
a number that the Gateway automatically provides if the calling IP
network endpoint does not provide a calling party number. Valid digits
are 0 through 9 You can enter up to 11 digits.
(Serial Gateways only) In the Display name for incoming calls field,
9
enter an alias for this serial port. The Gateway sends this alias to the IP
endpoint in serial-to-IP calls.
In the Supported Services section of the PRI Port or Serial Port tabs, you can
enable or disable specific Gateway services on each port. The Supported Services
section displays the following information in table form:
Prefix—Displays the prefix for this service.
Description—Displays a brief description of the service.
Call Type—Displays the call media type: Voice or Video.
Bit Rate—Displays the maximum total bit rate allowed for this service.
Support—Displays the status of the service: enabled or disabled.
Procedure
In the Gateway interface, on the sidebar, click Gateway (if not already
1
selected).
Click the applicable PRI Port or Serial Port tab.
2
Click Supported Services.
3
step
8.
Configuring the SCOPIA Gateway
Configuring Port Settings
step
7,
147
Advertisement
Table of Contents
