Setting Up The Scopia Tip Gateway; Mounting The Scopia Tip Gateway Onto The Rack Using A Shelf; Locating A Shelf In The Rack - RADVision SCOPIA TIP Deployment Manual

4

Setting up the SCOPIA TIP Gateway

Mount the device onto a 19" square-hole rack.
These sections describe how to set up the device:

Mounting the SCOPIA TIP Gateway onto the Rack Using a Shelf

This section describes how to mount the unit on to your rack:

Locating a Shelf in the Rack

Before choosing a shelf that will support the device, follow this procedure.
Procedure
Step 1
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
•
Mounting the SCOPIA TIP Gateway onto the Rack Using a Shelf ...................... page 13
•
Connecting Cables to the Device ......................................................... page 19
•
Setting the IP Address of the Device ..................................................... page 20
•
Verifying the SCOPIA TIP Gateway Installation ......................................... page 22
•
Locating a Shelf in the Rack ............................................................... page 13
•
Checking the Accessories Required for Mounting ....................................... page 14
•
Attaching Brackets to the SCOPIA TIP Gateway ........................................ page 15
•
Marking the Location of the Device-fixing Cage Nuts .................................. page 16
•
Removing the Cage Nut Screws ........................................................... page 17
•
Mounting the Device-fixing Cage Nuts ................................................... page 17
•
Mounting the SCOPIA TIP Gateway onto the Shelf ..................................... page 18
Read "Verifying Rack Suitability" on page
spacing information.
10, which contains important positioning and
Setting up the SCOPIA TIP Gateway | 13