Table of Contents
Advertisement
Configuring Gateway Settings
R
EFRESHING
G
S
ATEWAY
TATUS
C
ONFIGURING
G
ATEWAY
S
ETTINGS
84
SCOPIA 400/1000 Gateway User Guide
You can refresh the information that appears in the Status tab.
Procedure
In the Gateway interface, on the sidebar, click Gateway (if not already
1
selected).
2
Click the Status tab (if not already selected).
3
On the toolbar, click Refresh.
The information that appears in the Status tab is now refreshed.
In the Settings tab of the Gateway interface, you can configure gatekeeper and
Interactive Voice Response (IVR) addressing, the type of connection to the IP
network, dialing delimiters, media encoding/decoding protocols, Quality of
Service levels, which events cause the Gateway to send SNMP traps, Gateway
resource levels for T.120 enabled and audio transcoded video calls, security
settings, and advanced settings such as load balancing support.
The following topics discuss the settings you can configure in the Settings tab:
Configuring Basic Gateway Settings
Configuring IP Connectivity Settings
Configuring IVR Settings
Configuring Outgoing Call Delimiters
About Codecs
Configuring Codecs
Configuring ISDN Channel Bonding Settings for Downspeeding
page 98
Configuring Quality of Service
Configuring Alert Indications
Configuring Gateway Resources for Calls
Configuring Gateway Encryption
Configuring Advanced Settings
About DTMF Settings
Configuring Advanced Commands
on page 85
on page 92
on page 95
on page 97
on page 99
on page 101
on page 110
on page 111
on page 117
on page 121
on page 85
on page 94
on page 109
on
Advertisement
Table of Contents
