Table of Contents
Advertisement
Configuring Port Settings
C
P
ONFIGURING
ORT
P
HYSICAL
I
S
NTERFACE
ETTINGS
PRI P
ORTS
128
SCOPIA 400/1000 Gateway User Guide
6
(PRI Gateways only—optional) Select the Strip Local Area Code
check box if you want the Gateway to strip local area codes for
outbound calls to the ISDN network.
The type of line connected to this PRI port appears in the Physical
Note
standard field.
This section describes the available configuration options for Gateway ports.
PRI Ports
Serial Ports
This section applies only to Gateway P20 SP.
Note
In the Physical Interface section of the PRI Port tabs, you can configure the
physical line properties of the specified PRI port.
Procedure
In the Gateway interface, on the sidebar, click Gateway (if not already
1
selected).
Click the applicable PRI Port tab.
2
3
Click Physical Interface.
4
Select the Same as Port check box if you want to duplicate physical
interface settings from another PRI port that you choose from the field.
When selected, you cannot modify any settings in this section.
This option is not available in Gateways that support only one PRI
Note
port.
5
In the Interface field, choose the line interface: T1 or E1.
6
In the Country field, choose the nation where the ISDN service is
installed.
Advertisement
Table of Contents
