Table of Contents
Advertisement
.
C
ONFIGURING
F
RACTIONAL
C
HANNELS
7
In the Signaling protocol field, choose the signaling protocol used to set
up and tear down the calls through the signaling (D) channel.
Depending on the interface used, different signaling protocols are
available.
In the Network access field, choose the Gateway national access type:
8
TE (Terminal Equipment) or NT (Network Terminator) device.
In the Clock source field, choose the Gateway clock source:
9
Master (the Gateway provides the clock signal)
Slave (the Gateway receives the clock signal)
10
In the Line Build Out field, choose Long Haul or Short Haul.
You can configure this setting only if you select Japan in the Country
Note
field. Skip to
step 4
Related Topics
Configuring Fractional Channels
Configuring Line Coding, Framing and Signaling Type
In the Physical Interface section of the PRI Port tabs, you can configure
fractional channels as part of the physical line properties of the specified PRI
port.
Procedure
In the Gateway interface, on the sidebar, click Gateway (if not already
1
selected).
Click the applicable PRI Port tab.
2
Click Physical Interface.
3
4
Click Fractional to select fractional channels.
The Fractional dialog box appears.
Select the Fractional line check box to enable the fractional selection of
5
channels.
otherwise.
Configuring the SCOPIA Gateway
Configuring Port Settings
129
Advertisement
Table of Contents
