Table of Contents
Advertisement
C
ONNECTING THE
G
ATEWAY TO THE
N
ETWORK
C
PRI
ONNECTING
L
INES TO THE
G
ATEWAY
6
In the Password field, type the software password.
The default value is null.
To view the software components that will upgrade, click Customize.
Note
The Customize dialog box appears. If you do not want to upgrade a
component, deselect it.
7
Click Upgrade.
The upgrade process takes a few minutes. After the upload
completes, the Upload Complete Message dialog box appears.
Click OK.
8
The SCOPIA Gateway can connect to the LAN only through the front panel.
The Gateway supports a 10/100BaseT, full-duplex Ethernet interface through an
RJ-45 connector.
Procedure
Connect the supplied LAN cable from your network hub to the
1
10/100BaseT Ethernet port on the front panel of the Gateway.
The 10/100BaseT port accepts an RJ-45 connector.
2
Connect a separate ISDN or serial line to each PRI or serial
port in the rear panel of the Gateway. The port accepts an
RJ-45 connector.
You must connect a PRI line to at least one Gateway P20 SP port. The Gateway
supports T1 and E1 PRI configurations.
Connecting the Gateway to the Network
Installing the SCOPIA Gateway
39
Advertisement
Table of Contents
