Checking Your Gateway Environment; Checking Your Lan Environment - RADVision SCOPIA 400 User Manual

Checking Your Gateway Environment

C Y
HECKING OUR
G
ATEWAY
E
NVIRONMENT
C Y
HECKING OUR
LAN E
NVIRONMENT
166 SCOPIA 400/1000 Gateway User Guide
This section describes how to verify that your system status is operational and
whether or not the Gateway
Verification Steps
Check the Status screen in the Gateway, and table of endpoints in the
gatekeeper.
Check that the Gateway PRI/BRI synchronization is correct (the CD LED is
green on the Gateway board).
Check the ISDN connectivity to the public ISDN switch or the PBX/PABX.
Verify at Gateway > Board (or Device) > LED Monitoring that the far/near
(red/yellow) LEDs are off. If they are on, contact the ISDN provider.
(Serial
Gateway
connected to the RTM.
Check that the Gateway LAN interface is working at 100Mb/Full Duplex. If
not, hard code it on both sides (switch and Gateway) to 100Mb/Full Duplex and
restart both devices.
This section describes how to verify that your LAN network connection is
operating correctly.
Verification Steps
Check that your H.323 entities are properly registered to the gatekeeper.
Make a call between two LAN endpoints and verify the video and audio quality.
Verify that the LAN interface performance is satisfactory (no packet loss, jitter
or delay issues occur). Check with the network administrator if necessary.
is registered to a gatekeeper.
s only)
Verify that the Serial cables are properly