Table of Contents
Advertisement
C
ONFIGURING
A
DVANCED
C
OMMANDS
You can send text-based commands to the Gateway for enhanced control. You
can use these advanced commands to change certain settings in real time and
monitor information such as debug information. Advanced commands are not
case sensitive.
Table 3-18
describes common advanced commands.
Table 3-18
Advanced Command Settings
Command
AddService2SrcNum
CallSignalPort
DownSpeed (unavailable in
Gateway S40 SP)
EnhancedBillingForVoiceCalls
(unavailable in Gateway S40 SP)
ForceG711ForMcu
Configuring Gateway Settings
Description
Notifies the IP endpoint of the Gateway service
number to which the ISDN-side endpoint has
called.
Parameters: disable/enable.
Notifies the gatekeeper to which the Gateway is
registered on which port to communicate.
Parameters: 1000 to 3000.
Remarks: The number must be unique and not
used for any other purpose.
Instructs the Gateway to support downspeeding.
Parameters: disable/enable.
Instructs the Gateway to support the
RADVISION ECS CDR Real Connect Time
field. Real Connect Time indicates the actual time
at which an IP-to-ISDN voice call connects to the
ISDN terminal.
When disabled, the ECS uses the Connect Time
field for CDR billing purposes. Connect Time
indicates the time at which the Connect message
is sent to the source endpoint.
Parameters: disable/enable.
Remarks: Default value is disable. Relevant to
voice calls only. Operational only when the
Gateway is registered to an ECS working in
Routed Mode.
Instructs the Gateway to open only a G.711
channel in Gateway-to-MCU calls.
Parameters: disable/enable.
Configuring the SCOPIA Gateway
121
Advertisement
Table of Contents
