Table of Contents
Advertisement
C
ONFIGURING
C
ODECS
requirements of the H.320 standard govern this reallocation; the reallocation is
not configured in the Gateway. The Gateway simply decides whether or not to
send T.120 capabilities. You configure T.120 capabilities in the Advanced section
of the Gateway interface Settings tab.
In the Media Modes section of the Settings tab, you can configure and prioritize
encoding and decoding protocols.
Procedure
1
In the Gateway interface, on the sidebar, click Gateway (if it is not
already selected).
Click the Settings tab.
2
Click Media Modes.
3
In the Transcoding priority field, choose the priority that determines the
4
order of requested audio transcoding or choose Disable to disable audio
transcoding priority.
Note
When your unit includes both the
MCU, G.728 transcoding is supported on the MCU only.
RADVISION
You can configure the following audio codec settings:
5
Select the Enable G.722 check box to enable transparent support for
the G.722 audio codec.
Select the Enable G.722.1 check box to enable transparent support
for the G.722.1 audio codec.
Select the Enable G.728 check box to enable transparent support for
the G.728 audio codec.
You can configure the following video codec settings:
6
Select the Enable H.263 check box to enable transparent support for
the H.263 video codec.
Select the Enable H.263+ check box to enable transparent support
for the H.263+ video codec.
Select the Enable H.264 check box to enable transparent support for
the H.264 video codec.
Configuring Gateway Settings
Gateway and the
RADVISION
Configuring the SCOPIA Gateway
97
Advertisement
Table of Contents
