RADVision SCOPIA 400 User Manual page 115

Table 3-9 PRI Gateway SNMP Trap Event Types (continued)
Event Type Trap is sent when:
User logged out A user logs out of the system via the web
interface.
Table 3-10 Serial Gateway SNMP Trap Event Types
Event Type Trap is sent when ...
Abnormal A call has disconnected for a reason other
disconnect than normal, busy or no answer.
Authentication A login attempt to the web interface fails
failure (specific) due to incorrect user name or password.
Bad video Corrupt or empty video packets are present
in the Gateway. Includes the ID number of
the call during which the event occurs.
Cables mismatch A serial cable is not appropriate for the
configured serial port settings.
Call from The Gateway has rejected an incoming IP
non-peer H.323 call because the source does not appear in
entity rejected the peer list.
Call from peer A call from a peer has been rejected because
rejected due to the Gateway does not have enough
capacity resources available.
Call is out of There is a loss of synchronization for data
synchronization coming from the serial side (relevant only
when the Signaling protocol field is set to
Manual Control in the Physical Interface
section of the Port tab).
Call to peer failed A call to a peer has failed because the peer
- peer list empty list is empty.
Configuring Gateway Settings
State
State
TRUE
FALSE
Configuring the SCOPIA Gateway
Severity
Information
Severity
Warning
Warning
Minor
Clear
Warning
Warning
Warning
Warning
Major
105