Physical Description; Gateway Module - RADVision SCOPIA 400 User Manual

Physical Description

P
HYSICAL
D
ESCRIPTION
G M
ATEWAY ODULE
18 SCOPIA 400/1000 Gateway User Guide
This section provides a physical description of the Gateway modules and their
corresponding RTMs.
The Gateway module has a 10/100BaseT Ethernet port on the front panel that
uses an RJ-45 connector to connect to the network. There is an asynchronous,
9-pin serial port that you can use with a hyperterminal program to configure and
monitor the module.
Figure 2-1 shows the front panel components of the Gateway module.
describes these components.
Figure 2-1 Gateway Front Panel
Table 2-1 Front Panel Components
Component
ETHERNET connector
SERIAL connector
RST button
GK LED
CD LED
ACT LED
ALRM LED
Description
An RJ-45 connector that provides the primary Ethernet
connection for the IP network port.
A DB-9 connector that allows you to connect a PC
terminal for local configuration.
Allows you to reset the Gateway manually.
Lights green when the Gateway is registered with a
gatekeeper.
Lights green when at least one Gateway port connection is
online.
Lights green to indicate that there are active calls in the
Gateway.
Lights green to indicate that an error has occurred and the
Gateway requires resetting.
Table 2-1