Table of Contents
Advertisement
Configuring Gateway Settings
122
SCOPIA 400/1000 Gateway User Guide
Table 3-18
Advanced Command Settings (continued)
Command
NotifyLevel
Peer-to-Peer disconnect reason add
Peer-to-Peer disconnect reason
remove
Procedure
In the Gateway interface, on the sidebar, click Gateway (if not already
1
selected).
Click the Settings tab.
2
Click Advanced.
3
4
Click Commands.
The Advanced Commands dialog box appears.
5
Configure an advanced command by one of the following methods:
Description
Changes the type and number of debug messages
that are generated.
Parameters:
0—Disables Gateway logs.
3 (default)—Fatal error (Gateway can no longer
provide service), a problem affecting user
functionality (for example, call connect failure or
no resources available), or status prints for
Customer Support use.
6—Debugging.
8—Extended debugging.
Remarks: We recommend that you do not exceed
a NotifyLevel of 6 as this might overload the
system with a very large debug message output.
Level 3 should be sufficient for normal usage.
Instructs the Gateway under which circumstances
to reroute a call to different peer device.
Parameters: Enter a number representing the
required H.323 call disconnect reason, as listed in
Table
3-7.
Deletes the H.323 Call Disconnect Reason set by
the Peer-to-Peer disconnect reason add advanced
command.
Parameters: ALL—Enter a number representing
the required H.323 call disconnect reason, as
listed in
Table
3-7.
Advertisement
Table of Contents
