Configuring Udp Port For Ras On The Scopia Tip Gateway - RADVision Scopia TIP Gateway Deployment Manual

Configuring RTP/RTCP/SRTP Ports on the Scopia TIP Gateway
About this task
The Scopia TIP Gateway designates ports 16384-17584 for UDP audio media, and 12000-13200 for
UDP video media.
Procedure
1. Log in to the Scopia Management administrator portal.
2. Select Devices.
3. Select Gateways in the sidebar menu.
4. Select the relevant gateway from the Gateways list.
5. Select the Configure tab (see
6. Select Advanced Parameters Settings. The Advanced Parameters dialog box appears
7. Set the UDP video base port by doing the following:
8. Complete the video base port configuration as follows:
9. Set the audio base port by doing the following:
10. Select Close.
Deployment Guide for Scopia TIP Gateway Version 8.2
on page 33 ).
(see Figure 22: Configuring a gateway from Scopia Management
a. Enter the advcmdmvpsetval command in the Command field.
b. Enter the mf.BasePort parameter in the Parameter field to set the UDP video base port.
c. Enter the port value in the Value field.
d. Select Save.
a. Enter the mvpconfigcompletedcommand command in the Command field.
b. Enter 1 in the Value field.
c. Select Save.
d. Clear the value in the Parameter field before proceeding to the next step.
a. Enter the advcmdmapsetval command in the Command field.
b. Enter the mf.UdpBasePort parameter in the Parameter field.
c. Enter the port value in the Value field.
d. Select Save.
e. Enter the mapconfigcompleted command in the Command field.
f. Enter 1 in the Value field.
g. Select Save.
Figure 22: Configuring a gateway from Scopia Management
Configuring your Scopia Solution for Interoperability with Cisco
on page 33).
Telepresence | 34