Setting Up The Printer - NCR 7169 Owner's Manual

Introduction

Setting up the Printer

Before using the NCR Printer Flash Utility, the printer must first be set up. To set up the
printer, follow these steps:
1. Obtain the following information required for the interface settings:
2. Connect the printer to the terminal. For more information, refer to
• COM Port number—used in the COM interface. For more information, refer to
Obtaining the COM port number
• Baud rate, data bits, stop bits, parity—used in the COM interface. For more
information, refer to
page 8.
• IP address—used in the LAN interface. For more information, refer to
the Diagnostic Form using the paper feed button
printer to the terminal
on the next page.
Printing the Diagnostic Form using the paper feed button
on page 1.
on page 8.
Connecting the
1-5
on
Printing