Install The Foot Bracket Assemblies; No Pulser: Installing The Printer Feet - NCR OPTIC 12 Installation Instructions Manual

For gvr encore 500s

Hide thumbs Also See for OPTIC 12:

Table of Contents

Retrofit G7 Printer GVR Encore 500S (US) Installation Guide

6.2

Install the Foot Bracket Assemblies

1. Prepare for foot installation.

a. Remove the current Cover Plate using a 5/16" socket or nut driver. Retain the screws.

Discard the Cover Plate.

Screws being removed.

b. Place the Blank Base Plate (MP0649) aligning the screw holes as shown below.

2. Install feet brackets.

Note: Verify the correct foot bracket is installed to the correct side. The install steps are

the same but the slot configuration of the foot bracket are different from left to right side.

a. Obtain the feet brackets and place on the Blank base Plate.

Document Number

Date Released

Revision Number/Security level

Cover Plate removed.

DCV-00213

May. 2017

R01 S2

Table of Contents