Switch Settings; Setting Extra Rs-232C Options - NCR 7197 Owner's Manual

7197 Owner's Manual

Switch Settings

The DIP switches are located on the PC board at the back of the printer as shown in the
illustration in "Level 1 Diagnostics" in chapter 4.
The switches are used to put the printer into various modes for printer configuration set
up.
Use a paper clip or other pointed object to set the switches.
1. Set the switches to the desired settings shown in the table.
Caution: Do not set switch 1 to On. Setting switch 1 to On puts the printer in level 1
diagnostics (setup mode) where other functions and tests can be changed.
DIP Switch Settings
Switch 1
Setting
OFF (0)
ON(1)
OFF (0)
ON (1)
* It is optional to set this switch to ON when reflashing the IPL firmware.

Setting Extra RS-232C Options

The following extra options are available for the RS-232C Interface:
•
65
Printer End View
Switch 2 Setting
OFF (0)
OFF (0)
ON (1)*
ON (1)
Data errors
•
Print "?" for data errors (default)
•
Ignore data errors
Printer State
On-line Mode (default)
Diagnostic Mode
Flash Download Mode
Vendor Adjustment Mode
March 2002
Chapter 5: Communication