Replacing The Pressure Roll Assembly - Xerox Versant 3100 Press User Manual

Maintenance
1. Perform the steps for Removing the Fuser
2. Once the Fuser Belt Assembly is out of the press, you can access and remove the
Fuser Stripper Finger baffle:
a) Using the T10 Torx driver, remove the two screws and the Fuser Entrance Baffle.
Set aside the screws for reinstallation.
b) Note the position of the Fuser Belt Edge Sensor so as not to damage it when
removing the Pressure Roll.
c) Press the front and back Spring Levers at the same time and lift out the Stripper
Finger Assembly.
3. To replace the Stripper Finger Assembly, align the two slots in the assembly with the
two posts and click into place.
4. Position the Entrance Baffle by aligning the two perforations and the two screw holes.
5. Reinstall the two screws to secure the baffle.
6. Ask the administrator to reset the High Frequency Service Item (HFSI) count for this
newly-replaced CRU component at the press Control Panel.

Replacing the Pressure Roll Assembly

Caution
Make sure the press is powered off. Do not perform this replacement procedure with
the power on or electrical power supplied to the press. Allow the fuser to cool down for
50 minutes before performing any maintenance.
1. Perform the steps for Removing the Fuser
2. Perform the steps for Replacing the Stripper Finger
3. Once the Fuser Belt Assembly is out of the press and the stripper finger bracket
removed, you can access and remove the Pressure Roll Assembly:
a) Push down and release the front and back Bearing Holder Springs, and move
each spring into the holding position.
b) Install the Pressure Roll Handles under the bearings on each side of the roll.
c) Lift the Pressure Roll straight out of the press and place in an available box.
4. Install the new Pressure Roll Assembly. Use the Pressure Roll Handles to help position
the Pressure Roll in the Fuser Assembly.
5. Align the bearings to the cradle as you gently lower the Pressure Roll into place, and
then remove the handles.
6. Rotate the roll to ensure that the gears mesh properly.
6-34
Module.
Module.
Assembly.
®
Xerox
®
Versant 3100 Press
User Guide