Telnet; Traceroute - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Overview
Software Overview
Option
show isdn-group [<interface number>]
show lldp [<cr> | device <name> | interface <interface ID> |
<neighbors>]
show memory heap [realtime]
show modules
show processes cpu
show snmp
show sntp
show thresholds
show version
1-42

Telnet

Open a Telnet session. (You enable and set the parameters for Telnet sessions
from the Telnet line configuration mode context.)
Syntax: telnet <A.B.C.D>
For information on how to set up a Telnet session, see Chapter 2: Controlling
Management Access to the ProCurve Secure Router.

Traceroute

Ping an IP address and display the hops that the packet takes en route to the
destination.
Syntax: traceroute <A.B.C.D>
The router will display a route to a destination up to 30 hops away. You can
end the traceroute process at any time by pressing
Result
lists the ISDN group configurations and member
interfaces
displays LLDP settings and information, including
information on specific neighbors
displays statistics for the router memory, including how
much has been used and how much is available
gives information on the router's modules, including the
type of module in each slot and the number of ports in each
module
shows the process statistics, including the load percent
for each process
displays the SNMP information and packets received
shows SNTP information
displays the thresholds that have been exceeded on each
E1 or T1 interface
displays the router system software and hardware
versions
Ctrl+C .