Configuring The E1 + G.703 Module; Quick Start; Making The Physical Connection; Configuring The E1 Interface - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Quick Start

This section provides the commands you must enter to quickly configure a
G.703 interface or a DSX-1 interface on the ProCurve Secure Router. Only a
minimal explanation is provided.
If you need additional information about any of these options, see "Contents"
on page 9-1 to locate the section and page number that contains the explana-
tion you need.

Configuring the E1 + G.703 Module

Making the Physical Connection

1. Use unshielded twisted pair (UTP) cabling with RJ-48C connectors to
connect the E1 interface to the CSU provided by your Public Telephone
and Telegraph (PTT) authority.
2. Use crossover UTP cabling with RJ-48C connectors to connect the G.703
interface to the PBX.

Configuring the E1 Interface

When you configure a G.703 module, you first configure the E1 interface to
handle data communications. As part of this configuration, you assign the
number of channels that you will use for data to the E1 interface, and the
remaining channels are automatically assigned to the G.703 interface.
In addition, you can configure the clock source (rather than simply accepting
the default setting of line). For an E1 + G.703 module, the clock source is set
only on the E1 interface.
To assign the channels to the E1 interface, complete these steps:
1. From the global configuration mode context, enter the following
command:
Syntax: interface e1 <slot>/1
Replace <slot> with the slot number in which the module is installed. For
example, if the module is in slot one, enter:
ProCurve(config)# interface e1 1/1
Configuring the E1 + G.703 and T1 + DSX-1 Modules
Quick Start
9-23