Activating The Interface; Checking The Status Of The G.703 Interface - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Configuring the E1 + G.703 and T1 + DSX-1 Modules
Configuring the E1 + G.703 Module
9-10

Activating the Interface

All interfaces on the ProCurve Secure Router are administratively down by
default and must be activated. From the E1 interface configuration mode
context, enter:
ProCurve(config-e1 1/2)# no shut

Checking the Status of the G.703 Interface

After you assign the correct number of channels to each interface and then
configure the G.703 interface, the connection between the G.703 port and your
PBX should come up. You can use the show commands listed in Table 9-2 to
view both the status and the configuration information for the G.703 interface.
Table 9-2. show Commands
Command
show interfaces
show interface <interface> <slot>/<port>
show running-config
show running-config verbose
show running-config interface <interface
ID>
show running-config interface <interface
ID> verbose
For example, to check the status of the G.703 interface, enter:
ProCurve# show interfaces e1 <slot>/2
If you are not in the enable mode context, you can use the do command
and enter:
Syntax: do show interfaces e1 <slot>/2
Explanation
displays information about all the
interfaces—active or inactive—on the
ProCurve Secure Router
displays information about a specific physical
displays all of the settings that you have
configured for the ProCurve Secure Router
displays the entire running-config, including
the default settings
displays the settings that you have configured
for a particular interface
displays the running-config for a particular
interface, including the default settings