Snmp Settings; Enabling The Snmp Server And Snmp Traps - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Using the Web Browser Interface for Basic Configuration Tasks
Configuring Ethernet Interfaces
14-42
9. The Interface Mode pull-down allows you to choose IP routing or PPP
over Ethernet (PPPoE). The default setting is IP Routing. If you select
PPPoE and then click Apply, the PPPoE Configuration window is dis-
played. If you want to configure PPPoE for this interface, see "Configuring
PPPoE for the Ethernet Interface" on page 14-50.
a. If you are using the ProCurve Secure Router with a switch, 802.1q is
also listed as an option under the Interface Mode pull-down list.
Selecting this option enables VLAN tagging and displays the Ethernet
Subinterface Configuration settings you must define:
i. ID: A unique identifier between 1 and 4095 for this subinterface
ii. VLAN ID: The VLAN ID to use on this subinterface
iii. Native VLAN: Check the box if this subinterface is the native
VLAN; only one subinterface can be set as native
b. For more information on configuring Ethernet subinterfaces, see
"Configure VLAN Support" on page 3-19.
10. Click Apply to save the changes you have made to the startup-config.

SNMP Settings

If you are using a Simple Network Management Protocol (SNMP) management
console, you can use the Web browser interface to configure SNMP support
on the router.
For more information on SNMP settings and configuration, see Chapter 2:
Controlling Management Access to the ProCurve Secure Router.

Enabling the SNMP Server and SNMP Traps

1. Click SNMP in the navigation bar, and then select the Identity tab.