Expects To Receive; Configuring Peer Ip Address; Example Of Demand Routing With Pap Authentication - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Configuring Demand Routing for Primary ISDN Modules
Using Demand Routing for ISDN Connections
When you replace <password>, ensure that you are using the same settings
that are configured on the far-end router.
The username that is sent is the hostname of the router. If necessary, you can
override this username with this demand interface configuration command:
Syntax: ppp chap hostname <hostname>
Configuring the Username and Password That the Router

Expects to Receive

You must also configure the username and password that the ProCurve Secure
Router expects to receive from the far-end router. From the demand interface
configuration mode context, enter:
Syntax: username <username> password <password>
For example, you might enter:
ProCurve(config-demand 1)# username SiteB password procurve
For CHAP, the username should be the hostname of the peer.

Configuring Peer IP Address

You can also configure the IP address of the PPP peer for the dial-up WAN
connection. From the demand interface configuration mode context, enter:
Syntax: peer default ip address <A.B.C.D>
Replace <A.B.C.D> with the IP address of the far-end router.

Example of Demand Routing with PAP Authentication

Figure 8-15 shows a demand routing configuration that uses PAP authentica-
tion. The data-call commands enable PAP authentication for all demand
interfaces configured on the router. The ppp authentication pap command
enables PAP for the demand interface. The username command establishes
the username and password that the PPP peer will submit to the ProCurve
Secure Router. The ppp pap sent command configures the username and
password that the ProCurve Secure Router will send its peer.
8-55