HP ProCurve 7000dl Series Basic Management And Configuration Manual page 268

Configuring E1 and T1 Interfaces
Troubleshooting E1 and T1 WAN Connections
4-38
--------------------------------------------------------------------
t1 1/1 is UP
Receiver has no alarms
T1 coding is B8ZS, framing is ESF
Clock source is through t1 1/2, FDL type is ANSI
Line build-out is 0dB
No remote loopbacks, No network loopbacks
Acceptance of remote loopback requests enabled
Tx Alarm Enable: rai
Last clearing of counters never
loss of frame
loss of signal : 1, last occurred 00:10:41
AIS alarm
Remote alarm
DS0 Status: 123456789012345678901234
NNNNNNNNNNNNNNNNNNNNNNNN
Status Legend: '-' = DS0 is unallocated
'N' = DS0 is dedicated (nailed)
Line Status: -- No Alarms --
(OUTPUT TRUNCATED)--------------------------------------------------
Exit - 'Ctrl-C', Freeze - 'f', Resume - 'r'
Figure 4-13. Viewing the show interfaces Output in Real-Time
To end the output and return to troubleshooting the router, enter
: 1, last occurred 00:10:27
: 0
: 0
40
Instructions
for pausing
or ending
the output
.
Ctrl+C