HP ProCurve 7000dl Series Basic Management And Configuration Manual page 320

Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
Configuring the Logical Interface
Interface Command
Configuration
Mode Context
e1 • tdm-group <number> timeslots <range of
numbers>
• coding [ami | hdb3]
• frame format [e1 | crc4]
• clock source [internal | line | through]
• no shutdown
t1 • tdm-group <number> timeslots <range of
numbers]
• coding [ami | b8zs]
• frame format [esf | d4]
• clock source [internal | line | through]
• no shutdown
serial • serial-mode [EIA530 | V35 | X21]
• et-clock-source [txclock | rxclock]
• no shutdown
frame-relay • no shutdown
interface
• frame-relay intf-type [dte | dce | nni]
• frame-relay lmi-type [ansi | auto | cisco |
none | q933a]
6-24
From this configuration mode context, you can enter the
display the commands available from this configuration mode context.
ProCurve(config-fr 1)# ?
Table 6-4 shows the main settings that you must configure for an E1, T1, or
serial interface that uses Frame Relay.
Table 6-4. Frame Relay Configuration Options
Description
• defines the number of channels
used for the E1 connection
• defines the line coding
• defines the frame format
• defines the clock source, or timing,
for the connection
• activates the interface
• defines the number of channels
used for the T1 connection
• defines the line coding
• specifies frame format
• defines the clock source
• activates the interface
• configures the serial interface to
support the appropriate cable
• configures the serial interface to
take the clock from the transmit
signal, txclock, or from the receive
signal, rxclock
• activates the interface
• activates the interface
• defines the signaling role as user,
network, or both
• defines Frame Relay signaling type
help command to
?
Page
4-10
4-10
5-12
6-25