Quick Start - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Dynamic Host Configuration Protocol (DHCP)

Quick Start

13-34
Quick Start
This section provides the commands you must enter to quickly configure:
the router to act as a DHCP server for a subnet
the router to assign a fixed DHCP address to a single host
a router interface to act as a DHCP client
Only a minimal explanation is provided. If you need additional information
about any of these options, check "Contents" on page 13-1 to locate the section
that contains the explanation you need.
Table 13-2. DHCP Server Settings
Configurations
network's static IP
addresses
parent pool for a range of
subnets (optional)
DHCP pool for a subnet
servers
Parameters
first address in range
last address in range
other static address
pool name
range of subnets and prefix
length for range
pool name
subnet address and mask (or
prefix length)
default gateway
primary DNS server
secondary DNS server
primary WINS (NetBIOS)
server
secondary WINS (NetBIOS)
server
TFTP server
NTP server
Your Setting