HP ProCurve 7000dl Series Basic Management And Configuration Manual page 95

Overview
Software Overview
Enabling SafeMode. To enable SafeMode, access the global configuration
mode context and enter:
Syntax: safe-mode [<reload time> <threshold time>]
For example:
ProCurve(config)# safe-mode 600 500
ProCurve(safe-config)#
Set the <reload time> to the number of seconds to countdown until the
router reboots. Set the <threshold time> to the number of seconds to
countdown until you receive a reminder to reset the timer. Both the reload
time and threshold time must be between 30 and 3600 seconds. The default
value for the reload time is 300 seconds, and the default value for the threshold
time is 60 seconds. To enable SafeMode with the default settings, enter safe-
mode at the global configuration prompt.
The reload time should be greater than the threshold time. If you enter a
threshold value greater than the reload value, the CLI displays an error
message.
When you are configuring in SafeMode from a Telnet or SSH session, the
configuration mode context prompt is displayed as safe-config. For example:
ProCurve(safe-config)# interface ethernet 0/1
ProCurve(safe-config-eth 0/1)#
All configurations that you make during SafeMode are saved in RAM as part
of the running-config.
After the countdown for the reload timer has begun, it continues until you
either reset it by pressing , you disable it by entering no safe-mode, or
Ctrl+R
you exit out of the global configuration mode context.
Use the no form of the command to disable SafeMode and the countdown
timer:
ProCurve(safe-config)# no safe-mode
ProCurve(config)#
SafeMode Functioning. SafeMode events are displayed in the CLI. When
the threshold timer reaches zero, a notice is displayed in the CLI reminding
you to reset the timer:
SAFEMODE: SafeMode will reboot in <threshold> seconds.
1-63