Troubleshooting The Dsx-1 Interface; Viewing Configuration Information; Alarms Or Errors That Will Not Clear - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Viewing Configuration Information

To view the settings that have been entered on the ProCurve Secure Router,
enter:
ProCurve# show running-config
You must then browse through the output to find the DSX-1 interface. To view
only the running-config for the DSX-1 interface, enter:
ProCurve# show running-config interface t1 <slot>/2
Figure 9-6 shows the running-config for both the T1 and DSX-1 interfaces.
ProCurveSR7102dl# show running-config interface t1 2/1
interface t1 2/1
clock source through
tdm-group 1 timeslots 1-12 speed 64
no shutdown
ProCurveSR7102dl#show running-config interface t1 2/2
interface t1 2/2
signaling-mode none
no shutdown
Figure 9-6. show running-config Command for the T1 and DSX-1 Interfaces
To view all the settings (including default settings) for the T1 interface or
DSX-1 interface, add the verbose option to the show command:
ProCurve# show running-config interface t1 <slot>/2 verbose

Troubleshooting the DSX-1 Interface

To troubleshoot a DSX-1 interface, you must first isolate the problem. Is the
problem with the PBX? With the DSX-1 interface? With the T1 interface? Or is
the problem with the public carrier's equipment?

Alarms or Errors That Will Not Clear

When you are unable to clear alarms or errors in the Secure Router OS, the
device at the other end of the cable is often at fault. To isolate the problem,
disconnect the cable from the PBX and loop the DSX-1 interface back on itself
using an external cable. If the unit goes out of alarm, you know that the PBX
is at fault.
Configuring the E1 + G.703 and T1 + DSX-1 Modules
Configuring the T1 + DSX-1 Module
Channel assignment is listed
under the E1 <slot>/1
interface
9-21