Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
Configuring the Logical Interface
6-18
Replace <line> with a phrase up to 80 characters. For example, you
might enter:
ProCurve(config-ppp 1)# description WAN link to Denver office
This description is displayed only when you enter the show running-config
command. From the enable mode context, enter:
ProCurve# show running-config
You must then scroll through the running-config to find the interface ppp 1
heading. To view only the running-config for the PPP 1 interface, enter:
ProCurve# show running-config interface ppp 1
Configuration information such as the following is displayed:
interface ppp 1
description WAN link to Denver office
ip address 192.168.1.1 255.255.255.0
bind 1 ser 1/1 ppp 1
no shutdown
Settings Explained in Other Chapters
In addition to configuring these settings for the PPP interface, you can:
assign access control policies (ACPs) or access control lists (ACLs) to the
PPP interface
assign crypto maps to enable virtual private networks (VPNs)
configure settings for routing protocols
enable bridging
Table 6-3 lists additional configurations that you can enter from the PPP
interface and the page number where you find information about those
configurations.