Quick Start - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
To disable the hdlc debug messages, enter one of the following commands
from the enable mode context:
ProCurve# no debug hdlc [errors | verbose]
or
ProCurve# undebug all

Quick Start

After you configure the physical connection—the E1, T1, or serial interface—
you must configure the Data Link Layer protocol that controls the data being
transmitted across the WAN link. The ProCurve Secure Router supports the
following Data Link Layer protocols for E1, T1, and serial interfaces:
Point-to-Point Protocol (PPP)
Frame Relay
High-Level Data Link Control (HDLC)
This section provides the commands you must enter to quickly configure the
Data Link Layer protocol for an E1, T1, or serial interface. Only a minimal
explanation is provided.
If you need additional information about any of these options, see "Contents"
on page 6-1 to locate the section and page number that contains the explana-
tion you need. (For information about E1 or T1 interface, see Chapter 4:
Configuring E1 and T1 Interfaces. For information about serial interfaces,
see Chapter 5: Configuring Serial Interfaces for E1- and T1-Carrier Lines.)
PPP
To configure PPP for an E1, T1, or serial interface, complete these steps:
1. From the global configuration mode context, create a PPP interface.
Syntax: interface <interface> <number>
For example, you might enter:
ProCurve(config)# interface ppp 1
Quick Start
6-71