Show Running-Config Verbose Command - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Configuring E1 and T1 Interfaces
Viewing Information about E1 and T1 Interfaces
4-30
This command displays the configuration that you have entered for the entire
router. You must then scroll through the running-config until you locate the
appropriate E1 or T1 interface.
To save time, you can enter the following command from the enable mode
context:
Syntax: show running-config interface <interface> <slot>/<port>
For example, if you want to display the commands that you have entered for
the E1 1/1 interface, enter:
ProCurve# show running-config interface e1 1/1
Figure 4-8 shows the output for a sample network.
interface e1 1/1
clock source internal
tdm-group 1 timeslots 1-31 speed 64
no shutdown
Figure 4-8. show running-config <interface> <slot>/<port>
According to this display, the network administrator has entered only three
commands for this E1 interface:
ProCurve(config-e1 1/1)# clock source internal
ProCurve(config-e1 1/1)# tdm-group 1 timeslots 1-31
ProCurve(config-e1 1/1)# no shutdown

show running-config verbose Command

To view all of the settings—the commands you have entered and the default
settings—for an interface, enter the following command from the enable mode
context:
Syntax: show running-config interface <interface> <slot>/<port> verbose
For example, to view all of the settings for the E1 1/1 interface, enter:
ProCurve# show running-config interface e1 1/1 verbose
Figure 4-9 shows the verbose output for a sample network. Compare this
output with the output shown in Figure 4-8.
This output shows only the
commands that you have
manually entered.