Summary Of Ethernet Configuration Settings - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Configuring Ethernet Interfaces
Ethernet Interfaces
Setting
description
encapsulation 802.1q
full-duplex or half-duplex
ip address <A.B.C.D> <subnet
mask | /prefix length>
ip address dhcp
ip unnumbered <interface>
mtu <size>
no shutdown
speed [10 | 100 | auto]
3-14
interface eth 0/1
description Attached to building 1
ip address 192.168.1.1 255.255.255.0
no shutdown
You can also view the description by entering:
ProCurve# show running-config interface eth 0/1
This command displays the running-config settings for only the Ethernet 0/1
interface.

Summary of Ethernet Configuration Settings

Table 3-2 shows the main settings for configuring an Ethernet interface.
Table 3-2. Ethernet Interface Configuration Options
Description
include information about the interface
that can be viewed when you enter show
running-config
configures the interface to support
VLANs
defines whether the connection uses
full-duplex or half-duplex
assigns a static IP address to the
interface
configures the interface as a DHCP client
that receives its address from a DHCP
server
uses the IP address assigned to another
interface on the router
sets the maximum size that an Ethernet
frame can be before it is fragmented
activates interface
defines the speed at which data is
transmitted over the connection
Default Page
no default 3-13
no default 3-16
full-duplex 3-11
no default 3-5
no default 3-5
no default 3-5
1500 3-12
shutdown 3-4
auto 3-11