Logging In To The Router Through Telnet/Ssh; Logging In To The Router Through The Aux Port - HP HSR6800 Installation Manual

BootWare Validating...
Press Ctrl+B to enter extended boot menu...
Starting to get the main application file--cfa0:/HSR6800.bin!............
............................................................................
............................................................................
...
The main application file is self-decompressing.............................
............................................................................
............................................................................
............................................................................
....................................................................Done!
System application is starting...
Mainboard 1 is master.
User interface con1 is available.
Press ENTER to get started.
Press Enter, and the following prompt appears:
<HP>
You can now configure the router.

Logging in to the router through Telnet/SSH

1. After powering on the router, log in to the router through the console port.
2. Use the telnet server enable command and the ssh server enable command to enable the Telnet
and SSH function on the router, respectively, and use the user privilege level command to set the
user privilege level.
3. Connect the PC to the management Ethernet port or the copper Ethernet port on the router and
specify an IP address for the port.
4. Specify an IP address for the PC, making sure the PC and the port are in the same network
segment.
For more information about how to log in to the router through Telnet/SSH, see HP HSR6800 Routers
Configuration Guides.

Logging in to the router through the AUX port

1. After powering on the router, connect the console cable to the console port.
To configure the AUX port:
Step
1. Enter system view.
2. Enter AUX user interface view.
Command
system-view
user-interface aux 0
44