Logging In To The Router Through Telnet/Ssh - HP FlexNetwork HSR6802 Installation Manual

Press Ctrl+T to start memory test
Booting Normal Extended BootWare
The Extended BootWare is self-decompressing.......................Done.
****************************************************************************
*
*
*
****************************************************************************
Copyright (c) 2010-2017 Hewlett Packard Enterprise Development LP
Compiled Date
CPU Type
CPU L1 Cache
CPU Clock Speed
Memory Type
Memory Size
Memory Speed
Flash Size
cfa0 Size
NVRAM Size
BASIC CPLD Version
EXTENDED CPLD Version: 2.0
PCB Version
BootWare Validating...
Press Ctrl+B to access EXTENDED-BOOTWARE MENU...
Loading the main image files...
---- More ----
Press Enter, and the following prompt appears:
<HPE>
You can now configure the router.

Logging in to the router through Telnet/SSH

1. After powering on the router, log in to the router through the console port.
2. Use the telnet server enable command and the ssh server enable command to enable the
Telnet and SSH function on the router, respectively, and use the user privilege level
command to set the user privilege level.
3. Connect the PC to the management Ethernet port or the copper Ethernet port on the router and
specify an IP address for the port.
4. Specify an IP address for the PC, making sure the PC and the port are in the same network
segment.
For more information about how to log in to the router through Telnet/SSH, see HPE FlexNetwork
HSR6800 Routers Configuration Guides.
HPE Router BootWare, Version 2.04
: Nov 6 2016
: P2020
: 32KB
: 1000MHz
: DDR3 SDRAM
: 4096MB
: 667MHz
: 8MB
: 999MB
: 128KB
: 2.0
: Ver.B
39
*
*
*