Configuring Remote Access To The Procurve Secure Router; Configuring An Ethernet Interface - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Controlling Management Access to the ProCurve Secure Router
Quick Start
2-68
Configuring Remote Access to the ProCurve Secure
Router
You can access the ProCurve Secure Router through:
Telnet
SSH
HTTP
FTP
Secure Copy (SCP) server

Configuring an Ethernet Interface

Before you can access the router through a remote location, you must enable
at least one interface and provide a physical connection to either a LAN or
WAN. This section provides the minimum steps required to configure an
Ethernet interface and to connect that interface to your company's LAN. You
can then access the router from a workstation on the LAN. For more detailed
information about configuring an Ethernet interface, see Chapter 3: Config-
uring Ethernet Interfaces.)
1. Use a 10Base-T or 100Base-T cable to connect the Ethernet port to a
device (such as a switch) on your LAN.
2. Open your terminal session software and initiate a console session with
the ProCurve Secure Router, using the following parameters:
• Baud Rate = 9600
• Parity = None
• Data Bits = 8
• Stop Bits = 1
• Flow Control = None
3. Press when you are prompted to start a session with the router. The
Enter
router basic mode context prompt appears, as shown below:
ProCurve>
4. Access the enable mode context:
ProCurve> enable
5. Access the global configuration mode context:
ProCurve# configure terminal