Viewing The Status Of Hdlc Interfaces; Viewing Configuration Information - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
Checking the Status of Logical Interfaces
6-58

Viewing the Status of HDLC Interfaces

To view information about the HDLC interface, enter the following command
from the enable mode context:
Syntax: show interface hdlc <number>
Figure 6-19 shows the results of this command for a sample network.
hdlc 1 is UP
Configuration:
Keep-alive is set (10 sec.)
IP is configured
10.1.1.1 255.255.255.252
Link information:
Receive: bytes=6896, pkts=65, errors=0, broadcast=22
Transmit: bytes=8158, pkts=79, errors=0, broadcast=29
5 minute input rate 184 bits/sec, 0 packets/sec
5 minute output rate 216 bits/sec, 0 packets/sec
IP is UP Address=10.1.1.1 Mask=255.255.255.252
IP MTU=1500, Bandwidth=1984 Kbps
Figure 6-19. show interface hdlc <number>

Viewing Configuration Information

You can view the running-config for a logical interface by entering the follow-
ing command from the enable mode context:
Syntax: show running-config interface <interface> <number>
Replace <interface> with the logical interface and replace <number> with
the number you used to create that interface. For example, to view the
running-config for an HDLC interface, enter:
ProCurve# show running-config interface hdlc 1
Figure 6-20 shows the results of this command for a sample network.
interface hdlc 1
ip address 10.1.1.1
no shutdown
bind 1 e1 1/1 1 hdlc 1
Figure 6-20. show running-config interface hdlc <number>
Status of interface
255.255.255.252
IP address
MTU and bandwidth