HP ProCurve 7000dl Series Basic Management And Configuration Manual page 106

Overview
Troubleshooting
N o t e
1-74
The CLI will prompt you to save the system configuration. If you have already
made the configurations that you want to test, reply no. If you are getting ready
to make the configurations to be tested and want to save previous configura-
tions, reply yes. The CLI then displays:
You are about to reboot the system. Continue? [y/n]
Enter . The system will not reboot immediately. It will wait the amount of
y
time you have specified. Remember that while you are doing a delicate
configuration and using the reload in command, you must not save the
running-config to the startup-config (by entering either write memory or
copy run start). Otherwise, the ProCurve Secure Router will load these
configurations when it reboots.
To cancel the reload, enter:
ProCurve# reload cancel
SafeMode automates this process if you are configuring the router using a
Telnet or SSH session. (See "SafeMode" on page 1-62.)