Configure The Number Of Connect Sequence Attempts; Configure Settings For The Recovery State - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Configuring Demand Routing for Primary ISDN Modules
Using Demand Routing for ISDN Connections
Returning to the Default Connect Sequence Processing Order. To
return the connect-order command to its default setting of sequential,
enter:
ProCurve(config-demand 1)# no connect-order

Configure the Number of Connect Sequence Attempts

You can limit the number of times that the ProCurve Secure Router processes
the connect sequences configured for a demand interface if it is unable to
establish a connection. The router will process the connect sequences in the
order you specify (with the connect-order command). If the router processes
all of the connect sequences and is unable to establish a connection, the router
has made one connect sequence attempt. (Note that in one attempt, the router
can retry a particular connect sequence as many times as specified for that
connect sequence's busyout-threshold setting.) The router then repeats the
process until it reaches the number that you have specified in the connect-
sequence attempts command.
From the demand interface configuration mode context, enter:
Syntax: connect-sequence attempts <value>
Replace <value> with the number of times the ProCurve Secure Router will
cycle through the connect sequences specified for a demand interface. You
can specify a number between 0 and 65535. The default setting is 1. Specifying
0 places no limit on the number of attempts.

Configure Settings for the Recovery State

When the ProCurve Secure Router tries to establish a connection, one of the
following conditions will result:
A BRI Interface Is Available, and the Call Is Connected. If the
ProCurve Secure Router successfully establishes a physical connection
(Layer 1), it will begin to negotiate a PPP session with the far-end router.
No BRI Interfaces Are Available. If no BRI interface in the associated
resource pool is available for use, the ProCurve Secure Router places all
interfaces in the resource pool in fast-idle mode, which decreases the amount
of time an interface can remain idle before the router disconnects the ISDN
connection. The router then monitors the BRI interfaces until one becomes
8-33