HP ProCurve 7000dl Series Basic Management And Configuration Manual page 522

Configuring Demand Routing for Primary ISDN Modules
Quick Start
N o t e
8-84
b. Assign a BRI interface to the ISDN group. Enter:
Syntax: connect bri <slot>/<port>
Replace <slot> and <port> with the numbers that identify where the
BRI interface is installed. You can assign multiple BRI interfaces to
the ISDN group. For example, you might enter:
ProCurve(config-isdn-group 1)# connect bri 2/1
ProCurve(config-isdn-group 1)# connect bri 2/2
c. Assign the ISDN group to a resource pool. From the ISDN group
configuration mode context, enter:
Syntax: resource pool-member <poolname>
For example, if the resource pool is called Branch, enter:
ProCurve(config-isdn-group 1)# resource pool-member Branch
The ISDN group can be a member of only one resource pool.
d. To control which calls the BRI interfaces in the ISDN group accept,
enter the following command from the ISDN group configuration
mode context:
Syntax: incoming-accept-number <number>
For example, you might enter:
ProCurve(config-isdn-group 1)# incoming-accept-number 5551212
You can use the wildcard characters listed in Table 8-9 to specify a
range of numbers.
Table 8-21. Wildcard Characters for incoming-accept-number
Wildcard Characters
X
N
$
[ ]
Explanation
Matches any single digit between 0 and 9.
Matches any single digit between 2 and 9.
Matches any number (multiple numbers).
Matches any digit in the list. For example, if you enter [2,4,6] the
ProCurve Secure Router matches only 2, 4, and 6. If you enter
[4-6,8] the ProCurve Secure Router matches 4, 5, 6, and 8.