HP ProCurve 7000dl Series Basic Management And Configuration Manual page 323

Frame Relay Counter
frame-relay lmi-n391dce <polls>
frame-relay lmi-n391dte <polls>
frame-relay lmi-n392dce <threshold>
frame-relay lmi-n392dte <threshold>
frame-relay lmi-n393dce <counter>
frame-relay lmi-n393dte <counter>
frame-relay lmi-t391dte <seconds>
frame-relay lmi-t392dce <seconds>
Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
Table 6-6 lists the Frame Relay counters, the possible settings, and the polls
that each one controls.
Table 6-6. Frame Relay Counters
Possible
Settings
1-255
1-255
1-10
1-10
1-10
1-10
5-30 seconds
5-30 seconds
You can use the no command to return counters to their default settings.
Default Description
Setting
6 Configure how many link integrity polls occur
in between the full-status polls. Configure this
setting for the DCE endpoint.
6 Configure how many link integrity polls occur
between the full status polls. Configure this
setting for the DTE endpoint.
3 Configure an error threshold number for the
DCE. If the error threshold is met, the signaling
status is changed to down, which indicates a
service-affecting condition. This condition is
cleared after this number of consecutive
error-free N393 events are received.
3 Configure an error threshold number for the
DTE. If the error threshold is met, the signaling
status is changed to down, which indicates a
service-affecting condition. This condition is
cleared after this number of consecutive
error-free N393 events are received.
4 Configure the LMI- monitored event counter
for the DCE endpoint.
4 Configure the LMI- monitored event counter
for the DTE endpoint.
10 seconds Set the T391 signal-polling timer for the DTE
endpoint.
10 seconds Set the T392 polling-verification timer for the
DCE endpoint.
Configuring the Logical Interface
6-27