HP ProCurve 7000dl Series Basic Management And Configuration Manual page 697

N o t e
Managing Files, Firmware, Boot Software, and the AutoSynch™ Function
Figure 14-15. View/Manage Debug Output
For a complete explanation of the output for each debug filter in the Web
browser interface, see the corresponding CLI debug command in the
troubleshooting section of the applicable chapter in this manual or the
ProCurve Secure Router Advanced Management and Configuration
Guide.
8. You can click the following buttons on the screen while debug is running:
• Pause Debug and Restart Debug—to pause and then restart the debug
output on the screen. While the output is paused, you can examine
the existing debug messages, but no new messages will be generated
until you restart the output.
• Stop Debug—to stop the debug output. If you want, you can then add
or delete debug filters and start the debug output again (see Steps 2
through 7).
If you click the Stop Debug, Add Debug Filter, or Remove Selected Events
button while debug is running, the current debug output on the screen will
be lost.
Using the Web Browser Interface for Basic Configuration Tasks
14-19