Viewing Information About The Serial Interface; Show Interfaces Serial Command - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Viewing Information about the Serial
Interface
You can view information about the E1- and T1-carrier line associated with
the serial interface, and you can view the configuration settings that have been
entered for the serial interface.

show interfaces serial Command

To view information about the serial interface and the carrier line associated
with it, enter the following command from the enable mode context:
Syntax: show interfaces serial <slot>/<port>
You can also use the do command to enter this command from any context
(except the basic mode context). For example, from the global configuration
mode context, enter:
ProCurve(config)# do show interfaces serial 2/1
This command displays information about the serial interface in slot two. (See
Figure 5-7.)
ser 2/1 is UP, line protocol is UP
Status of interface
Figure 5-7. show interfaces serial Command
The first line reports the status of the interface. The status will be one of the
following:
Encapsulation FRAME-RELAY IETF (fr 1)
Transmit clock source is TCLK
DCD=up DSR=up DTR=up
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
4624 packets input, 0 bytes, 0 no buffer
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 701 frame
8 abort, 0 discards, 0 overruns
4803 packets output, 0 bytes, 0 underruns
up
administratively down
down
Configuring Serial Interfaces for E1- and T1-Carrier Lines

Viewing Information about the Serial Interface

RTS=up CTS=up
Data Link Layer protocol
(logical interface)
5-15