Viewing Settings Configured For The Isdn Group - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Configuring Demand Routing for Primary ISDN Modules
Viewing Information about Demand Routing
8-64
As Figure 8-18 shows, this command also lists multiple channels if MLPPP is
configured for the ISDN connection.
demand 1
Idle timer (120 secs), Fast idle timer (20)
Dialer state is data link layer up
Dial reason: ip (s=192.168.1.23, d=192.168.2.23)
Link thru 1_0(bri 2/1.1) is up
Time until disconnect 106
Last outgoing call
Last incoming call
Link thru 1_1(bri 2/1.2) is up
Time until disconnect 106
Last outgoing call
Last incoming call
Number of active calls = 2
Figure 8-18. Summary Information for Demand 1 Interface

Viewing Settings Configured for the ISDN Group

You can view both the default and the configured settings for a particular ISDN
group. From the enable mode context, enter:
Syntax: show isdn-group <number>
Replace <number> with the number of the group for which you want to view
information. For example, to view the settings for ISDN group 2, enter the
following command from the enable mode context:
ProCurve# show isdn-group 2
Figure 8-19 shows the settings for an example ISDN group.
ISDN group 2
Call type digital-64k
Accept number $
min channels 0
max channels 0
resource pool-member Pool10
interface bri 1/1
Figure 8-19. Viewing Settings for an ISDN Group
MLPPP is
enabled
Default settings