HP ProCurve 7000dl Series Basic Management And Configuration Manual page 102

Overview
Help Tools
N o t e
1-70
2. Copy the Secure Router OS software from a TFTP server by entering:
bootstrap# copy tftp flash
Address of remote host? <A.B.C.D>
Source of filename? J06_03.biz
Destination filename? J06_03.biz
You can also copy the Secure Router OS software from a compact
flash card.
bootstrap# copy cflash <filename> flash [<filename>]
3. If your router uses the standard boot process, you should copy the new
software as SROS.BIZ to both the compact flash memory (if your router
uses a compact flash card) and the internal flash.
bootstrap# copy flash J06_03.biz cflash SROS.BIZ
bootstrap# copy flash J06_03.biz flash SROS.BIZ
4. Alternatively, you can enter the boot system command and specify the
new Secure Router OS software by entering:
Syntax: boot system [flash | cflash] <filename>
bootstrap# boot system flash J06_03.biz
This option, however, is not recommended because you must then enter
a new boot system command whenever you upgrade the router's soft-
ware.
5. Enter reload or boot to reboot the system.
A quicker and easier way to replace corrupted software is to make sure that
you have an uncorrupted backup copy of the Secure Router OS on compact
flash. If you have a compact flash card with the good copy of the Secure Router
OS, you only need to insert it into the router and boot it. Then copy the
uncorrupted version to flash and erase the corrupt version.