HP ProCurve 7000dl Series Basic Management And Configuration Manual page 677

1. Move to the interface configuration mode context. For example:
ProCurve(config) int fr 1.101
2. Configure the router to take a dynamic address from a server.
Syntax: ip address dhcp
a. For a default configuration, simply enter the command without any
options. For example:
ProCurve(config-fr 1.101)# ip address dhcp
b. You may not want the interface to take its default gateway, domain
name, or DNS servers from the DHCP server. In this case, enter the
ip address dhcp command with one or more of the following options:
Syntax: ip address dhcp [hostname <name> | no-default-route | no-domain-
name | no-nameservers]
c. You should usually accept the default ID generated from the inter-
face's MAC address. However, you can configure a customized client
ID. You can also configure a hostname for the interface that is differ-
ent from the router's hostname. Enter the ip address dhcp command
with one of these options:
Syntax: ip address dhcp [client-id {<ethernet <slot>/<port> |
HH:HH:HH:HH:HH:HH:HH} | hostname <name>]
For example, enter:
ProCurve(config-fr 1.101)# ip address dhcp client-id 0f:ff:ff:ff:ff:ff:ff
Dynamic Host Configuration Protocol (DHCP)
Quick Start
13-39