Configuring the Data Link Layer Protocol for E1, T1, and Serial Interfaces
Settings Explained in Other Chapters
In addition to configuring these settings for an HDLC interface, you can:
assign ACPs or ACLs to control access to the HDLC interface
enable bridging
assign crypto maps to enable VPNs
configure settings for routing protocols
configure QoS settings
Table 6-10 lists additional configurations that you can enter from the HDLC
interface and the page number where you find information about those
configurations.
Table 6-10. Additional Configurations for the HDLC Interface
Settings
access controls to filter incoming and outgoing traffic
bridging
VPNs
routing commands for OSPF, RIP, or BGP
QoS settings
Configuring the Logical Interface
Configuration
Page
Guide
Advanced
5-19, 5-38
Basic
10-6
Advanced
10-46
Advanced
15-1
Advanced
8-28
6-47