Show Running-Config Commands - HP ProCurve 7000dl Series Basic Management And Configuration Manual

Configuring Ethernet Interfaces
Viewing the Status of Ethernet Interfaces or Subinterfaces
N o t e
3-22
-------------------------------------------------------------------
eth 0/1 is UP, line protocol is UP
Hardware address is 00:12:79:05:25:B0
Ip address is 192.168.1.1, netmask is 255.255.255.0
MTU is 1500 bytes, BW is 100000 Kbit
100Mb/s, negotiated full-duplex, configured full-duplex
ARP type: ARPA; ARP timeout is 20 minutes
5 minute input rate 208 bits/sec, 0 packets/sec
5 minute output rate608 bits/sec, 1 packets/sec
47 packets input, 7448 bits/sec, 1 packets/sec
244 packets input, 22907 bytes multicasts input
192 unicasts, 52 broadcasts, 0 multicasts input
0 input errors, 0 runts, 0 giants
0 no buffer, 0 overruns, 0 internal receive errors
0 alignment errors, 0 crc errors
3 packets output, 512 bytes
204 packets output, 16642 bytes multicasts output
193 unicasts, 1 broadcasts, 10 multicasts output
0 single, 0 multiple, 0 late collisions
0 excessive collisions, 0 underruns
0 internal transmit errors, 0 carrier sense errors
(OUTPUT TRUNCATED)--------------------------------------------------
Exit - 'Ctrl-C', Freeze - 'f', Resume - 'r'
Figure 3-6. Results of the show interface ethernet realtime Command
To end the realtime display of the show interface ethernet command, enter
To suspend the updates and maintain the current display, enter
Ctrl+C.
the updates again, enter

show running-config Commands

Located in RAM, the running-config file includes the configurations that are
currently running on the router—this includes the configurations that were
read from the startup-config when the ProCurve Secure Router was booted,
and any configurations that you have subsequently entered. The running-
config is cleared every time the ProCurve Secure Router is powered down,
and any changes that have not been saved to the startup-config file are lost.
To save the running-config to the startup-config file, you must enter one of the
following commands from the enable mode context:
write memory
copy running-config startup-config
.
r
Instructions
for pausing
or ending
the output
To view
f.