Examining The Router After Power-On; Configuring Basic Settings For The Router - HP FlexNetwork MSR3064 Installation Manual

Image file cfa0:/msr3000-cmw710-boot-e000603.bin is self-decompressing......
..........Done.
System image is starting...
Line aux0 is available.
Press ENTER to get started.
Press Enter, and the following prompt appears:
<HPE>
You can now configure the router.
NOTE:
To access the CLI when the device boots with empty configuration, press Ctrl+D.

Examining the router after power-on

After the router is powered on, verify that:
•
The LEDs on the front panel are operating correctly:
LED
PWR
SYS
•
The configuration terminal displays information properly. For local configuration, the
configuration terminal displays the boot information (see
•
If you press Enter as prompted after system bootup, the router is ready to configure.

Configuring basic settings for the router

After the router is powered on for the first time, configure the basic settings for the router. For more
information, see HPE MSR Routers Fundamentals Configuration Guide (V7) and HPE MSR Routers
Fundamentals Command Reference (V7).
Status
Steady green
Slow flashing green
38
Description
The power supply is supplying power correctly.
The router is operating correctly.
"Displaying boot information").