Table 13: Configuration Wizard Session - Static Ip Configuration - Mellanox Technologies Spectrum SN2740 Hardware User Manual

The table below shows an example of static IP configuration for mgmt0 interface.
Table 13 - Configuration Wizard Session - Static IP Configuration
Mellanox configuration wizard
Do you want to use the wizard for initial configuration? yes
Step 1: Hostname? []
Step 2: Use DHCP on mgmt0 interface? [yes] no
Step 3: Use zeroconf on mgmt0 interface? [no]
Step 4: Primary IP address? [for example 192.168.10.4] 10.10.10.10
Mask length may not be zero if address is not zero (interface eth0)
Step 5: Netmask? [0.0.0.0] 255.255.255.0
Step 6: Default gateway? [for example 192.168.10.1] 10.10.10.255
Step 7: Primary DNS server?
Step 8: Domain name?
Step 9: Enable IPv6? [yes]
Step 10: Enable IPv6 autoconfig (SLAAC) on mgmt0 interface? [no]
Step 11: Admin password (Enter to leave unchanged)?
Otherwise hit <enter> to save changes and exit.
To return to the wizard from the CLI, enter the "configuration jump-start"
command from configure mode. Launching CLI...
>
Rev 2.2
Wizard Session Display - Static IP Configuration (Example)
To change an answer, enter the step number to return to.
Choice:
Configuration changes saved.
Mellanox Technologies
Installation
59