Dell PowerConnect B-FCXs Configuration Manual page 304

8
Configuring STP related features
TABLE 53
This field...
Hello
Port IEEE 802.1W parameters
Port Num
Pri
Port Path Cost
P2P Mac
Edge port
Role
State
Designated Cost
Designated Bridge
To display detailed information about 802-1W, using the following command.
262
CLI display of 802.1W summary (Continued)
Displays...
The hello value derived from the Root port. It is the number of seconds
between two Hello packets.
The port number shown in a slot#/port# format.
The configured priority of the port. The default is 128 or 0x80.
The configured path cost on a link connected to this port.
Indicates if the point-to-point-mac parameter is configured to be a
point-to-point link:
•
•
Indicates if the port is configured as an operational Edge port:
•
•
The current role of the port:
•
•
•
•
•
Refer to
the roles.
The port current 802.1W state. A port can have one of the following
states:
•
•
•
•
Refer to
port states"
The best root path cost that this port received, including the best root
path cost that it can transmit.
The ID of the bridge that sent the best RST BPDU that was received on
this port.
T – The link is configured as a point-to-point link.
F – The link is not configured as a point-to-point link. This is the
default.
T – The port is configured as an Edge port.
F – The port is not configured as an Edge port. This is the default.
Root
Designated
Alternate
Backup
Disabled
"Bridges and bridge port roles"
Forwarding
Discarding
Learning
Disabled
"Bridge port states" on page 232 and
on page 233.
PowerConnect B-Series FCX Configuration Guide
on page 228 for definitions of
"Edge port and non-edge
53-1002266-01